Hello, I'm a gunsmithstudent from Finland, and I have this Win.'03.22 rifle, which I had from my dad.

Unluckily the firing pin and this other part (The one which is pulling an empty casing away after shot is taken) are broken, and I dont know what they have looked before.
Im planning to make new ones, so:
I would be really really thankful if somebody could tell me where to find explode pictures or instructions about this gun and those parts, so i would know what they were looking a like.

I already gone throw quite many pages, and just could not find what I was looking for..

Thanks for help, Jori

Welcome to the forum. This may help, there are exploded parts diagrams for many guns:

www.e-gunparts.com

If not, www.brownells.com may be a good resource.

Good luck!

FINgun, Here are the part numbers and the cost from www.gunpartscorp.com

Firing pin P/N 383700 cost: $13.50

Extractor P/N 998410 cost: $11.25

You might also look into the Taurus Mod. 62 for parts, as they are a copy of the old Winchester 03 except in .22 long rifle caliber. They may fit, or at least be used as a pattern for the parts that you need.

FINgun, Here are the part numbers and the cost from www.gunpartscorp.com

Firing pin P/N 383700 cost: $13.50

Extractor P/N 998410 cost: $11.25

You might also look into the Taurus Mod. 62 for parts, as they are a copy of the old Winchester 03 except in .22 long rifle caliber. They may fit, or at least be used as a pattern for the parts that you need.


Thanks for help everyone, this helps a LOT. And I also find quite nice viewfinder for that gun in those sites..:)