Hi folks.

I'm in need.

I just purchased a Remy 7600 in 30-06. Not a scratch on it, kinda looks brand new. Has a cheapo scope on it, and....gasp.... those ididotic see thru mounts. I don't know why, but I've got a notion to keep em on there. I can't even get me eyes down to the open sights because the comb is so tall, but frer some reason; they look like they belong. I'll eventually take em off but right now, I think I'll give em a shot, pun definitely intended.

So, the needed help is; a trajectory table with the line of sight 2.25" above bore. All I have is Lee loader and it just does .75(open sights) and 1.5 for scope. If any of you would feel like running such parameters for me, I'd sure like to see it and would really appreciate it. I have dialup so I usually don't do much as far as downloading and such(for sites that do this). Would appreciate 2" high at 100 or maybe 150 zero. Don't really need the whole list, but would like to know where it crosses under one of these parameters at 50 yards. That is where I shoot out my back door for rough "home zeroing".

Shooting Remy 165 CoreLokt, but 150 or 180 will do. I just need a little insight so I can get this close before I waste time at the range. Of course, any shooting is not wasting time. :)

Thanks.

Here is one of the best. Hope this helps. Just follow the directions. Take care...
Oberndorf



http://www.beartoothbullets.com/rescources/calculators/balistics/index.htm

That link doesn't work now. Go here:

http://www.eskimo.com/~jbm/calculations/calculations.html

Bye
Jack

Thanks. Appreciate the link. Worked fine.